Grass-valley iTX Output Server 2 v.2.6 Manual de usuario descargar pdf (Pagina 36)

Output Server 2 Channel Configuration

Setting a Reference, Frame Rate Family and Output Timing

You can set a manual reference and frame rate from the Configuration panel of the I/O

Device Controller user interface.

Note: The Reference and Frame Rate Family for the channel must be

specified from the I/O Device Controller user interface before a Resolution

can be selected in the Channel tab of the Output Server 2 user interface.

To set the reference, frame rate family or output timing control:

1 On the playout server running the service, maximize the S

erver Controller application.

If Server Controller is not running, it can usually be found in Start>All Programs>iTX

2.0.

2 Select the C

ontrolled Services tab.

All of the services running on that server are listed.

3 Double-click on I/O Devic

e Controller.

The I/O Device Controller user interface appears.

4Click the Co

nfiguration tab.

The C

onfiguration panel appears.

5On the Reference drop-down list, if you are using an external reference, this should be

set to

External, otherwise select Freerun.

6 If you are using manual reference, select a value from the Fra

me Rate Family drop-

down list (e.g.

50.00 Hz).

This will determine the resolution you can set in the Channel tab of the

Output Server 2

user interface. See S

electing the Channel Resolution and Frame Rate on page 32 for

more information.

7 You can adjust the horizontal and vertical output timing relative to a time reference

signal using the c

ontrols in the Output Timing Control (Ext. Ref. Only) section. This

allows the SDI I/O card to synchronize an incorrectly timed video input signal to the

time reference signal.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 74 75

Sin comentarios

Grass-valley iTX Output Server 2 v.2.6 Manual de usuario Pagina 36